The Router is to directly cut the PCB whole assembly PCB, if the equipment is in operation, the Router spindle can not suck. So it will lead to the PCB cut effect not good, or broken the PCB , will also cause economic losses, in the face of the spindle suction problem, how should we solve this problem?

1, Spindle suction failure maybe the program is not set, or the program has a BUG, to check in time whether it is the problem of program setting.

2, Spindle suction failure may be a problem with the chuck, because the chuck is a wearing part, life must be replaced, can not continue to use. So check if there is a problem with the chuck.

3, confirm whether the specification of the router bit is correct, if the wrong specification of the router bit is selected, it will also lead to the adsorption of the spindle is unstable or it cannot suck the router bit at all.

4, Spindle suction failure, or the spindle may be abnormal, resulting router bit can not be absorbed, so that it can not depanel.

5, it is possible that the working air pressure of spindle is not enough, or the cutting speed is too fast. We can try to reduce the speed of spindle, or increase the working air pressure to improve its working efficiency. However, it should be noted that this adjustment parameter should be adjusted according to the specific situation, and can not be blindly modified.

In short, the problem ofSpindle suction failure is common in the use of the PCB Router, but as long as we understand the reasons and take the right solution, we can easily solve this problem and ensure the quality of the PCB depaneling

This article is organized by Genitec original, reproduced must indicate the source: www.genitec.tw, please respect the results of labor, copyright infringement will be prosecuted!